Sony RM-VL700T Bedienungsanleitung Seite 28

Assigning Other Components to
the Component Select Buttons
(continued)
Each component is assigned to
the Number Buttons as follows.
1: VCR
3: SAT
4: AMP
5: CD
6: TAPE
To assign a digital cable box, select
the Number button 3 (SAT).
Notes
• In this step, only the factory-set
function is assigned. Other newly
"learned" functions (page 15) are not
assigned.
• If a component to be assigned has
any "learned" signals, the indicator
SET flashes twice. Then setting
cannot be performed. In this case,
clear the "learned" signals and follow
Steps 1 - 3 again, or select another
Component Select button which is
not assigned to "learned" keys or
buttons.
• You can copy the "learned" remote
control signals of a Component Select
button to another button (page 29).
4
•If you need to set the
component code, follow
the steps on pages 8 to 9.
•If you need to programme
some signals by the
Learning function, follow
the Steps 1 and 3 to 7 on
pages 15 to 17.
To cancel setting, press SET.
GB
28
7: MD
8: TV
9: CBL
0: DVD
To reset a Component Select
button to its original setting
Perform the setting of the original
component following the
procedure on page 27. Note
however if the original component
has any "learned" signals, setting
cannot be performed.