Titling a MiniDisc (continued)
To add characters
1
Put the unit in the character input mode.
(Perform steps 1 - 2 on page 36.)
2
Press the VOL + or VOL – button to move
the cursor to the right of the character, where
you want to add a new character.
3
Select the character to add.
(Perform steps 3 - 4 on page 36.)
4
Press the ENTER button.
5
Press the EDIT button.
6
"TOC" will be displayed. To write the up-
dated contents to the MiniDisc press the
•
/:OFF button.
You cannot remove the MiniDisc whilst "TOC" is dis-
played. "TOC" will not disappear until the recorded
contents have been updated.
E-38