Restoring The Factory Settings - EASYHOME Cube LAN Gateway Bedienungsanleitung

7. Restoring the factory settings

The cube can be reset to the initial state manually.
When the factory settings are restored, all informa-
tion about taught-in de-
vices and all settings made
are lost and cannot be ret-
rieved.
• Disconnect the cube from the
power supply and wait for 1
minute.
• Press and hold down the reset
button and at the same time reconnect the power supply.
• The Power LED lights up and then starts to flash.
• The Power LED then lights up permanently again. The
factory settings are restored.
22