Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Contents of packing
1× Pendulum Stroke Jig Saw
2× Saw blade
1× Parallel stop
1× Vacuum hose adapter
1× Allen key
1× Instruction manual
7. Intended use
The jig saw is intended for split cuts and
cutouts in wood, plastic and rubber. The jig
saw can be used for straight and curved
cuts at 0° to 45°.
8. Inserting the saw blade
Always disconnect the main power plug
prior to performing any work on the
machine.
Use only T-shank jig saw blades.
Lift the transparent blade cover (12) up
8.1
and hold it.
Pull the lever of the blade clamp and
8.2
slide the saw blade into the groove as
far as it will go with the blade teeth
pointing forward. Make sure that the lug
of the blade fitted into the blade clamp,
then release blade clamp lever (17),
check the blade held firmly.
Place the transparent blade cover to
8.3
initial position.
Attention: After a cut, the saw blade will be
very hot because of the friction. Be careful
when removing the saw blade. Protect your-
self by wearing appropriate protective
gloves.
9. Power on/off
Insert the mains plug into the socket.
9.1
The LED indicator light (14) lights up
and indicates that power is applied.
To turn on the pendulum stroke jig saw,
9.2
press the ON/OFF switch (3). The
switch can be set to continuous mode
by pressing the power on lock (2).
Pressing the ON/OFF switch (3) again
9.3
returns the power on lock (2) to the
starting position.
To turn off the pendulum stroke jig saw,
9.4
release the ON/OFF switch.
7062849-Jig_Saw_800W-Ma-1803-09.indb 7
10. Startup
Take note of the line voltage. The voltage of
the power source must match the informa-
tion on the type label on the machine.
220 V~ – 240 V~ can also be operated with
230 V~ units.
• Before switching on of the jig saw, the
front of the base plate (8) must lie flat
on the workpiece. Make sure that the
base plate rests securely on the entire
surface.
• Always hold the jig saw firmly with both
hands. Make sure that the saw blade is
not in contact with the workpiece before
the jig saw is turned on.
• Make sure that the saw blade has com-
pletely stopped before removing the jig
saw from the workpiece.
11. Stroke rate selection
You can adjust the stroke rate with the
stroke rate controller (1). The required
stroke rate of the saw blade is dependent on
the material and the saw blade used, and
should be determined by practical tests.
Material
Stroke adjustment
Wood . . . . . . . . . . 5 — 6
Soft steel
. . . . . . . . 3 — 6
Stainless steel . . . . . . . 3 — 4
Aluminium . . . . . . . . 3 — 6
Plastic
. . . . . . . . . 1 — 4
Attention: Do not let the jig saw run in con-
tinuous operation with the lowest speed. As
a result, the motor can overheat.
12. The diagonal cut
The mitre angle is variable between 0° and
45°.
English
7
22-03-18 11:07
Werbung
Inhaltsverzeichnis
