Connecting To The Control Panel; Connecting The Temperature Sensor - Calira EVS 17/16-DS/IU Betriebsanleitung

-

Connecting to the control panel

Plug the 7-pole ribbon cable into your control panel. The assignation of the
contacts is according to the following list:
Contact 1
Contact 2
Contact 3
Contact 4
Contact 5
Fig. 15:
Contact 6
7-pole connector
Contact 7
Plug the 7-pin ribbon cable into the associated port on the device (Fig. 4, pos.
9). The ribbon cable can only be inserted into the correct socket on the device
when in the correct position. Do not use any force.

Connecting the temperature sensor

If a temperature sensor is used for battery 2, plug the
temperature sensor cable into the temperature sensor
port (Fig. 4, pos. 7) of the device (2-pin connection).
Fig. 16: Temperature
sensor
44
Lerchenfeldstr. 9 87600 Kaufbeuren Tél. : +49(0)8341 / 9764-0 Fax : +49(0)8341 / 67806
$% ./ ./#)% *+
Negative connection
Positive test connection for battery 2
Positive test connection for battery 1
Control connection for consumer relay
Output for charge control
Output for Tremat signal
Control connection for pump relay
! " #