Description - Hilti UH 700 Bedienungsanleitung

Obligation signs
Wear a hard Wear eye
hat protection
Wear Read the
protective operating
gloves instructions
before use.
Symbols
Return Hammer
materials for drilling
recycling
Amps Hertz
Alternating Double
current insulated

2 Description

2.1 Use of the product as directed
The power tool is a hand-held, mains-powered hammer drill for hammer drilling, rotary drilling and screwdriving.
Under certain conditions, the power tool is also suitable for mixing (see "Applications").
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Modification of the power tool or tampering with its parts is not permissible.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Observe the national health and safety requirements.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The power tool may be used only in a dry environment.
Do not use the power tool where there is a risk of fire or explosion.
Wear Wear ear
breathing protection
protection
1
2
Drilling Drilling
without without
hammering, hammering,
1st gear 2nd gear
Volts Watts
Revolutions
per minute
Location of identification data on the power tool
The type designation, item number, year of manufacture
and technical status can be found on the type identific-
ation plate on the machine or tool. The serial no. can
be found on the underside of the motor housing. Make
a note of this data in your operating instructions and
always refer to it when making an enquiry to your Hilti
representative or service department.
Type:
Serial no.:
en
15