Hama Disc Bedienungsanleitung Seite 8

• In addition, a voice announces 'connected left channel' for
the left earphone and 'connected right channel' for the right
earphone.
5.4 Automatic Bluetooth
(after successful pairing)
Note
• Make sure that your Bluetooth
and Bluetooth
• For more information, please refer to the operating instructions
of your terminal device.
• Ensure that the earphones are switched on.
• You can only switch on the master. The master will automatically
connect to the terminal device after successful pairing. If the other
earphone is likewise switched on, it connects to the master and so
is likewise automatically paired with the terminal device.
• After the devices have been paired, a connection is established
automatically.
• You can now use the headset.
Note
• If pairing was successful, the status LEDs (3) flash blue every five
seconds.
• It may be necessary to change the settings on your terminal device
to enable it to automatically connect to the paired headset.
Note – Connection impaired
After the devices have been paired, a connection is established
automatically. If the Bluetooth
automatically, check the following:
• Check the Bluetooth
whether it is connected to the Hama Disc headset. If not, repeat
the steps listed in Section 5.3 Bluetooth
terminal device.
• Check whether obstacles are impairing the range. If so, move the
devices closer together.
• The performance can also be affected by a weak battery.
connection
®
is activated.
®
®
settings of your terminal device to see
®
-capable terminal device is on
®
connection is not established
pairing with
®
7