Device Functions; Setting The Signal Code - VOLTCRAFT LSG-10 Bedienungsanleitung

c) Device Functions
Display illumination
The display can be lit at any time if you are working in a badly lit environment.
To switch on the transmitter (LSG-10B), hold down the button with the light icon (15) for about 2 seconds.
Repeat this for switching it off again. Switch off the display illumination manually when you no longer
need it.
Briefly press the button with the light icon (8) at the receiver (LSG-10). Repeat this for switching it off again.
Switch off the display illumination manually when you no longer need it.
Switching on the Torch
An LED torch is integrated in the receiver.
Press the button with the torch icon (5) for switching it on or off. After approx. 1 minute, the LED lamp goes
out automatically to protect the battery.
Deactivate acoustic signal at the receiver
In normal operation, the acoustic display is always on. The signal sound can be switched off for quiet
areas of use (e.g. offices, theatre, etc.). Keep the button with the sound icon (8) pressed for about 2
seconds. The display shows a crossed-out speaker symbol. For switching it on, hold down the button
again for about 2 seconds. The speaker symbol disappears.
Auto-Power-Off
Transmitter and receiver switch off automatically after a certain time if no button is pressed. This function
protects the battery, saves battery power and extends the service life.
Auto-off time receiver approx. 10 minutes
Auto-off time transmitter: approx. 1 hour
d) Setting the Signal Code
The default setting for the signal code is 1. If you want to use several transmitters in one cable test, the
transmitter code can be changed to a value between 1 and 7.
To set it, proceed as follows:
Switch off the transmitter.
Keep the "LEVEL" (15) button pressed and turn on the transmitter. Then
release the operating button (16). The pre-determined signal code
appears in the display. Now release the other button.
Pressing the button "LEVEL" again will switch one code up each time and
then start again from the beginning.
When you have set the desired code, press the operating button (16)
shortly. The transmitter returns to the normal operating mode. The selec-
ted code is active and displayed.
36