Sony CDP-XB740 Bedienungsanleitung Seite 5

Hookups
xWhen making analog hookups
When connecting an audio cord, be sure to match the
colour-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
CD player
ANALOG OUT
L
R
z
You can adjust the output level to the amplifier
Press ANALOG OUT LEVEL +/– on the remote. You can
reduce the output level up to –20 dB.
When you reduce the output level, "FADE" appears in
the display.
When you turn off the player, the output level
automatically returns to the maximum level.
Note
If you press the ANALOG OUT LEVEL +/– buttons on the
remote while recording, the recording level will change even
when it is preset on the tape deck, etc.
xWhen making digital hookups
You can avoid deterioration of the signal during
transmission, since the music signal output through
the digital output connectors retains digital form.
You can connect a digital component such as a
digital amplifier, D/A converter, DAT or MD. When
you connect a DAT or MD, you can make digital
recordings from CDs.
Note that you cannot use the following functions
when making this connection:
• Fading in or out (see page 17)
• Time Fade (see page 17)
• Adjusting the output level using the ANALOG
OUT LEVEL +/– buttons on the remote (see
above)
• If you have a digital component with an optical digital
input connector
Connect the component via the DIGITAL OUT (OPTICAL)
connector using the optical cable (not supplied). Take off
the cap and plug in the optical cable.
Amplifier
INPUT
CD
L
• If you have a digital component with a coaxial digital
R
input connector
Connect the component via the DIGITAL OUT (COAXIAL)
Z
connector using the coaxial cable (not supplied).
Note
When you connect via the DIGITAL OUT connector, noise
may occur when you play CD software other than music, such
as a CD-ROM.
z
Connecting the mains lead
Connect the mains lead to a wall outlet.
Where do I go next?
Now you're ready to use your player.
If you aren't familiar with how to play CDs, go to the section
"Playing a CD" on page 6.
Then, go to the following sections for other operations.
Getting Started
Getting Started
CD player Digital component
DIGITAL OUT
COAXIAL OPTICAL
CD player Digital component
DIGITAL OUT
COAXIAL OPTICAL
If you have a Sony component with the CONTROL A1
(or CONTROL A1) jack
Connect the component via the CONTROL A1 jack. You
can simplify the operation of audio systems composed of
separate Sony components. For details, refer to the
supplementary "CONTROL-A1 Control System"
instructions.
DIGITAL IN
OPTICAL
DIGITAL IN
COAXIAL
5 GB