Troubleshooting - Elinchrom Transmitter PRO Gebrauchsanleitung

TROUBLESHOOTING

Pressing and holding in the left and right Speed buttons approximately 2 seconds, will reset the Transmitter
Pro to manufacture settings. All user settings, except the display contrast, will be reset.
HAVING THIS PROBLEM?
THE UNIT IS NOT SWITCHING ON
FLASH UNIT CANNOT BE TRIGGERED WHEN
THE MODE "ALL" IS SELECTED
SOME UNITS ARE NOT TRIGGERING WHEN
THE GROUP MODE IS SELECTED
THE TEST BUTTON WORKS, BUT THE CAMERA
WILL NOT TRIGGER FLASH UNITS
SOME INFORMATION IS NOT DISPLAYED
ABOUT DIGITAL RX, RANGER RX OR STYLE
RX UNITS
PLEASE CHECK THE FOLLOWING POINTS:
• Check battery polarity and replace both
discharged batteries.
• Transmitter and receiver must have the same
frequency channel settings.
• ELSP MODE: transmitter and receiver must
have the same synchronisation mode settings:
normal or speed sync mode.
• Check that the Skyport receiver in all EL-units
with built-in receivers, is switched on.
• Check that the transmitter version corresponds
to your camera brand.
• Check the Group settings of the EL- flash unit.
• Reduce the distance to any unresponsive unit.
• Transmitter and receiver must have the same
synchronisation mode settings: normal or speed
sync mode, and frequency channel settings.
• Check the hotshoe fitting.
• Check the camera settings (turn hotshoe
communication on).
• Check that the transmitter version corresponds
to your Canon or Nikon camera.
• Check the list of compatible cameras.
• Units equipped with a plug-in Transceiver RX
are limited in remote features. These units can
however be triggered and controlled (but with
no visual feedback) by the Transmitter Pro.
• Update the firmware of the Transmitter Pro.
User Manual
EN
17