Troubleshooting; Technical Data - DS Produkte FS9006 Gebrauchsanleitung

EN

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact the cus-
tomer service department.
Do not attempt to repair a defective electrical device yourself!
Problem
The device cannot be
switched on.
The fuse in the fuse
box is triggered.

Technical Data

Article number:
Model:
Voltage supply:
Power:
Protection class:
Short-term operation (KB): 5 minutes
Cutting thickness:
18
Possible cause
The mains plug is not insert-
ed correctly in the socket.
The socket is defective.
No mains voltage is present.
The device is not assembled
correctly.
The device is not switched
on.
Too many devices connected
to the same circuit.
No error can be identifi ed.
00417
FS9006
220 – 240 V ~ 50 Hz
150 W
II
0 – 15 mm
Fix
Insert the mains plug.
Try another
socket.
Check the fuse of the mains
connection.
Check whether the cutting
blade is seated on the drive
shaft correctly.
Move the switch I / /O / II (1)
to position I for constant oper-
ation or II for safe operation.
Reduce the number of devic-
es in the circuit.
Contact our customer service
department.
Customer Service /
Importer:
DS Produkte GmbH
Am Heisterbusch 1
19258 Gallin
Germany
Tel.: +49 38851 314650
(Calls to German landlines
are subject to charges. The cost
varies depending on the service
provider.)
All rights reserved.