Operate The Producer Iv; Install The Carousel; Remove The Carousel; Load The Discs - Rimage Producer P-IV 8200N Bedienungsanleitung

Operate the Producer IV

Install the Carousel

Tip: To prevent errors, install the carousel before operating the software or
powering on the autoloader.
1. Open the front door.
2. Install the carousel in the Producer IV.
a. Slide the carousel straight in so that the center post slides through
the slot opening of the bearing guide.
b. Rotate the carousel until the top support bearing lowers into the
bearing guide.
3. Close the front door.
2002543_A
Top Support Bearing
Bearing Guide
Center Post
For more information visit

Remove the Carousel

Remove the carousel from the autoloader to load or unload discs.
Important! If the Rimage software is currently running an operation on the
autoloader, wait for the software to complete the operation, or pause the
software operation before removing the carousel.
1. Open the front door.
2. Grasp the bottom of the carousel with two hands.
3. Lift the carousel off the carousel platter until the top support bearing
clears the bearing guide.
4. Move the carousel out of the autoloader.

Load the Discs

You can load up to 100
discs in each bin. You
can either remove the
carousel to load discs,
or use the procedure
below to place discs in
a bin.
1. Open the front
door.
2. Press the operator
button to rotate the
carousel and place
a bin in position to
load discs.
rimage.com/support
10