AEG L 99696 DFL Benutzerinformation Seite 16

16 www.aeg.com
The buzzer sounds and the display shows
that the programme is saved.
Set a memorised programme: Touch
the button where you memorised the
programme you want to set.
The programme indicator comes on and
the display shows all the information.
To cancel a memorised
programme you can only
memorise a new
programme.
7.4 Start/Pauze - Départ/Pause
Touch button Start/Pauze - Départ/Pause
to start or interrupt a programme.
7.5 Startuitstel - Départ
Différé
Touch button Startuitstel - Départ Différé
to delay the start of a programme from
30 minutes to 20 hours.
7.6 Tijd Besparen - Gain de
Temps
Touch button Tijd Besparen - Gain de
Temps to decrease the programme time.
You can select:
• SHORTENED DURATION: to wash
items with daily soil.
• EXTRA QUICK: to wash quickly items
with almost no soil.
Some programmes accept
only one of these functions.
7.7 Extra Spoelen - Rinçage+
Touch button Extra Spoelen - Rinçage+
to add rinsing phases to a programme.
Use this function for persons allergic to
detergents and in areas where the water
is soft.
7.8 Vlekken - Taches/Voorwas
- Prélavage
Touch this button to set one of the
following functions:
• Prewash
Use this function for heavy soil. The
appliance adds a prewash phase to
the main wash. The programme
duration increases.
• Soak
Use this function for heavy soil. The
appliance soaks the laundry at 30°C
for about half an hour before to wash.
• Stains
Use this function for laundry with hard
stains to remove. When you set this
function, put the stain remover into
compartment
The programme duration
increases. This function is
not available with a
temperature lower than
40° C.
7.9 T./min.
Touch button T./min. to:
• Decrease the maximum speed of the
spin phase of the programme.
The display shows only
the spin speeds available
for the set programme.
• Deactivate the spin phase ( 'No spin'
function).
• Activate the Rinse Hold function.
Set this function to prevent fabric
creases. The appliance does not drain
the water when the programme is
completed.
7.10 Temp.°C
Touch this button to change the default
temperature.
Symbols and
.
= cold water