Special Safety Instructions - Power Craft 55063 Gebrauchsanweisung

INSTRUCTION MANUAL

Special safety instructions

For use with SDS type drills and chisels only.
Always wear protective glasses when using for
drilling or chiselling or similar tasks where chips,
sparks and splinters can fly up.
Never drill into a wall or other surface/item without
checking what is on the other side. If the machine
comes into contract with electrical cables, pipes etc,
it can cause major material damage and can
become conductive if you cut an electrical cable.
Never use the chisel function with the drill chuck,
as it may damage the chuck.
Never switch between drill and chisel/hammel drill
whilst the machine is running.
Preparation
Fitting chisels and drill bits
•
Apply a little grease to the shaft of the item to
be fitted.
•
Pull collar (1) back and insert item into
bushing (2).
•
Turn collar until the item is locked in place.
Release collar.
Fitting support handle
• Fit support handle (3) and secure in posiiton
required by turning clockwise.
Fitting depth stop
• The depth stop (14) is used to stop the drill
at a preset depth.
• Loosen the support handle by turning
anticlockwise.
ENGLISH
• Insert depth stop in hole on support handle.
• Set depth stop to desired depth and tighten
handle.
Use
Selecting drill and hammer functions
The drill function selector (7) switches between
drilling and hammer drilling. The chisel function
selector (4) switches between drilling and
chiselling.
• Fornon-hammer drilling in soft materials,
the hammer drill function selector must be
aligned with the drill symbol, and chisel
funcion selector aligned with the drill- and
hammer symbol.
• For drilling with hammer function in hard
materials, the hammer function selector must
be aligned with the drill- and hammer symbol,
and the chisel function selector aligned with
the drill- and hammer symbol.
16