Barbecook Tam Tam Handbuch Seite 8

This guarantee is limited to the repair or replace-
ment of parts which prove defective under normal
use and service.
This guarantee shall not apply to defects due to
TROUBLESHOOTING
-
lation
No spark is produced
when trying to light the
barbecue
There is a spark but no
ignition when trying to
light the barbecue
Delayed ignition
Burner ignites but does
not stay lit
Excessive flames on
burner
Flashback fire at burner
- Ignition electrode or piezo not connected
to lead wire
- Electrode, lead wire or switch is defective
- Air still present in the tube between
cylinder and burner
LOW
- Electrode not positioned correctly
LOW
- Burner ports are fouled
- Fouled injectors
- Defective gas valve
- No more gas
- Defective gas valve
- Fouled burner ports
- Too much wind
- Incorrect mix of primary air and gas at
burner inlet
- Fouled injector
- Defective gas valve
- Blocked injector
- Fouled or blocked burner ports
- Incorrect primary air mix
improper installation, incorrect use, alterations to
the appliance, disassembly of the appliance, wear
and tear, or lack of maintenance.
Solution
- Screw cylinder all the way down onto unit.
- Check presence and condition of gasket
between cylinder and cylinder holder.
- Close gas valve on unit
- Connect lead wire between ignition electrode
and piezo.
- Replace defective part.
- Try to relight
- Replace gas cylinder
- Replace gas valve
- Sparks should be generated between electrode
and burner. Bend electrode into position.
- Replace gas cylinder
- Clean burner ports
- Clean injectors
- Replace gas valve
- Replace gas cylinder
- Replace gas valve
- Clean burner ports
- Unscrew burner and clean burner inlet and net
located at burner inlet
- Clean injector
- Replace gas valve
- Check injectors
- Clean burner ports
- Unscrew burner and clean burner inlet and net
located at burner inlet
8