Lake People PHONE-AMP G100 Bedienungsanleitung Seite 12

THE HIGH OUTPUT LEVELS
ACHIEVABLE WITH THIS UNIT MAY
DAMAGE YOUR HEARING
OR THE HEADPHONES
IF OPERATED CARELESSLY !!
Connection / Connectors for Analog Signals
ANALOG SIGNALS
XLR MALE PLUG
HOT
COLD
SHIELD
BALANCED INCOMING SIGNAL
ANALOG SIGNALS
XLR MALE PLUG
HOT
GND
SHIELD
BALANCED INCOMING SIGNAL
2-wire cable should be prefered !!
ANALOG SIGNALS
zum
Kopfhörer
CAUTION
Balanced Cable (Signal) to (Transformer) Balanced Input
Shield = Signal Ground = Pin 1
2 1
Hot / + Phase = Pin 2
Cold / - Phase = Pin 3
3
The case of the connector should not be wired
to the shield of the cable. The connector is routed
X to earth potential (PE) when plugged into the
corresponding socket of the case !
Unbalanced Cable (Signal) to (Transformer) Balanced Input
Shield = Signal Ground = Pin 1
2 1
Hot / Signal = Pin 2
Cold / Ground = Pin 3
3
The case of the connector should not be wired
?
to the shield of the cable. The connector is routed
X
to earth potential (PE) when plugged into the
corresponding socket of the case !
6.3 mm (1/4") Phone Jack ( ip -
- 12 -
T R S
ing - leeve Connector)
Tip = left Channel
Ring = right Channel
Sleeve = Ground