Hughes & Kettner era2-series Handbuch Seite 2

Important Safety Instructions!
Read before connecting!
This product has been built by the manufacturer in
accordance with IEC 60065 and left the factory in
safe working order. To maintain this condition and
ensure non-risk operation, the user must follow the
advice and warning comments found in the operating
instructions. The unit conforms to Protection Class
1 (protectively earthed). If this product shall be used
in vehicles, ships or aircraft or at altitudes exceeding
2000 m above sea level, take care of the relevant
safety regulations which may exceed the IEC 60065
requirements.
WARNING: To prevent the risk of fire and shock
hazard, do not expose this appliance to moisture or
rain. Do not open case – no user serviceable parts
inside. Refer service to qualified service personnel.
This symbol, wherever it appears, alerts you to
the presence of uninsulated dangerous voltage inside
the enclosure – voltage that may be sufficient to
constitute a risk of shock.
This symbol, wherever it appears, alerts you to
the presence of externally accessible hazardous
voltage. External wiring connected to any terminal
marked with this symbol must be a "ready made
cable" complying with the manufacturers
recommendations, or must be a wiring installed by
instructed persons only.
This symbol, wherever it appears, alerts you to
important operating and maintenance instructions in
the accompanying literature. Read the manual.
This symbol, wherever it appears, tells you:
Take care! Hot surface! To prevent burns you must
not touch.
All electrical and electronic products including
batteries should be disposed of separately from the
municipal waste stream via designated collection
facilities appointed by the government or the local
authorities.
Read these instructions. Keep these
instructions. Follow all warnings and instructions
marked on the product and in this manual.
• Do not use this product near water. Do not place
the product near water, baths, wash basins, kitchen
sinks, wet areas, swimming pools or damp rooms.
• Do not place objects containing liquid on the
product – vases, glasses, bottles etc.
• Clean only with dry cloth.
• Do not remove any covers or sections of the
housing.
• The set operating voltage of the product must
match the local mains supply voltage. If you are
not sure of the type of power available consult your
dealer or local power company.
• To reduce the risk of electrical shock, the grounding
of this product must be maintained. Use only the
power supply cord provided with this product, and
maintain the function of the center (grounding) pin
of the mains connection at any time. Do not defeat
the safety purpose of the polarized or grounding-
type plug.
• Do not defeat the safety purpose of the polarized
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
• Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the device! Power supply cords should always be
handled carefully. Periodically check cords for cuts
or sign of stress, especially at the plug and the point
where the cord exits the device.
• Never use a damaged power cord.
• Unplug this product during lightning storms or
when unused for long periods of time.
• This product can be fully disconnected from mains
only by pulling the mains plug at the unit or the wall
socket. The product must be placed in such a way
at any time, that disconnecting from mains is easily
possible.
• Fuses: Replace with IEC127 (5x20mm) type and
rated fuse only! It is prohibited to use "patched
fuses" or to short the fuse-holder. Replacing any
kind of fuses must only be carried out by qualified
service personal.
• Refer all servicing to qualified service personnel.
Servicing is required when the unit has been
damaged in any way, such as:
- When the power cord or plug is damaged or frayed.
- If liquid has been spilled or objects have fallen into
the product.
- If the product has been exposed to rain or moisture.
- If the product does not operate normally when the
operating instructions are followed.
- If the product has been dropped or the cabinet has
been damaged.
• Do not connect external speakers to this product
with an impedance lower than the rated impedance
given on the product or in this manual. Use only
cables with sufficient cross section according to the
local safety regulations.
• Keep away from direct sunlight.
• Do not install near heat sources such as radiators,
heat registers, stoves or other devices that produce
heat.
• This apparatus is for moderate climates areas use,
not suitable for use in tropical climates countries.
• Do not block any ventilation openings. Install in
accordance with manufacturer's instructions. This
product must not be placed in a built-in installation
such as a rack unless proper ventilation is provided.
• Always allow a cold device to warm up to ambient
temperature, when being moved into a room.
Condensation can form inside it and damage the
product, when being used without warming up.
• Do not place naked flame sources, such as lighted
candles on the product.
• The device must be positioned at least 20 cm/8"
away from walls with free air space inbetween,
and there must be free air space of at least 50 cm
/ 20" immediately above the unit within which no
object(s) may be placed or positioned.
• Use only with the cart, stand, tripod, bracket or
table specified by the manufacturer or sold with
the product. When a cart is used, use caution when
moving the cart/product combination to avoid
injury from tip-over.
Version 2.5 10/2017
• Use only accessories recommended by the
manufacturer, this applies for all kind of
accessories, for example protective covers,
transport bags, stands, wall or ceiling mounting
equipment. In case of attaching any kind of
accessories to the product, always follow the
instructions for use, provided by the manufacturer.
Never use fixing points on the product other than
specified by the manufacturer.
• This appliance is NOT suitable to be used by any
person or persons (including children) with limited
physical, sensorial or mental ability, or by persons
with insufficient experience and/or knowledge to
operate such an appliance. Children under 4 years
of age must be kept away from this appliance at all
times.
• Never push objects of any kind into this product
through cabinet slots as they may touch dangerous
voltage points or short out parts that could result in
risk of fire or electric shock.
• This product is capable of delivering sound
pressure levels in excess of 90 dB, which may cause
permanent hearing damage! Exposure to extremely
high noise levels may cause a permanent hearing
loss. Wear hearing protection if continuously
exposed to such high levels.
• The manufacturer only guarantees the safety,
reliability and efficiency of this product if:
- Assembly, extension, re-adjustment, modifications
or repairs are carried out by the manufacturer or by
persons authorized to do so.
- The electrical installation of the relevant area
complies with the requirements of IEC (ANSI)
specifications.
- The unit is used in accordance with the operating
instructions.
- The grounding of the center pin of the mains plug is
maintained to reduce the risk of shock.
Things to do before operating the amp
• Please read these instructions carefully,
particularly the notes on safety, before operating
the amp.
• The manufacturer disclaims any liability on
responsibility whatsoever for any damage or
defect to this and other devices resulting from
misuse.
• Before you plug this amp into a mains power
outlet, make sure its Power and Standby
switches are off and that the voltage rating
indicated on its rear panel matches your local
mains current.
• A word of warning before you fire up your
era 1 era 1 / era 2 era 2: It's loud, and high volume levels can
cause hearing damage. To avoid very loud and
unwelcome surprises, make a habit of backing
the Volume knob of the guitar connected to the
era 1 / era 2 era 1 era 2 all the way down before switching on
the amp!