Connecting To Power - AKG CU 4000 Bedienungsanleitung

• DC input
L
Refer to fig. 1.
Refer to fig. 2.
18
2 Description
• The tricolor (red/orange/green) RECOVER LED alerts you to the necessity of running a
recovery cycle for the BP 4000 and indicates the current recovery status.
• The RECOVER key starts the recovery cycle.
• The DC 12 V jack on the rear panel accepts the DC cable on the included power sup-
ply or a connecting cable to the optional PSU 4000 central power supply.

3 Connecting to Power

1. Check that the AC mains voltage stated on the included power supply is identi-
cal to the AC mains voltage available where you will use your system. Using the
power supply with a different AC voltage may damage the unit.
2. You can power the charger in one of two ways:
• Use the included power supply.
• Connect the DC 12 V jack to the DC OUT 2 or DC OUT 3 12 V output jack on the op-
tional PSU 4000 central power supply. (DC OUT 1 is reserved for powering a com-
plete antenna network.)
3. The charger is ready to operate. Note that all LEDs remain dark.
CU 4000