Dispensing Hot Water - Melitta CAFFEO SOLO&milk. Bedienungsanleitung

10

Dispensing hot water

Prerequisite: The appliance must be ready for operation (see „Switching on
and off" on page 54).
• Push the chrome-plated outer casing of the steam pipe upwards
(Fig. K, no. 2).
• Hold a vessel under the steam pipe.
Warning!
There is a risk of burn injuries and scalding due to the hot water
splashing and the hot steam pipe.
When dispensing hot water directly after dispensing steam, the remaining
steam will initially escape from the steam pipe and can cause the hot water to
splash.
– Avoid direct skin contact with hot water and the hot steam pipe.
Turn the valve switch (Fig. A, no. 11) clockwise to the stop to open the
•
valve.
→ The valve symbol
into the vessel.
• As soon as the desired quantity of water is reached, turn the valve
switch anti-clockwise to the stop to close the valve.
Note
The dispensing of hot water stops automatically when reaching a volume of
approx. 150 ml. If you want to dispense more hot water, please turn the valve
switch off and on again.
Heft_SoloMilk_EU_2_3.indd 61
flashes. Hot water flows out of the steam pipe and
61
09.04.2014 10:58:01