Renkforce DL-LED107S-UV Bedienungsanleitung Seite 22

This symbol indicates the minimum distance to the illuminated surface. Illuminated objects must
be at least 0.5 m away from the device's light emission source. Easily flammable materials such as
decorative fabrics must also have a distance of at least 0.5 m to the device. Otherwise, such objects
may catch fire!
Never put any filter foils, masks or other materials over the light exit. This may cause heat damage
and danger of fire.
When mounting the product, make sure that the power cord is neither jammed nor damaged by
sharp edges.
During installation or service work, the area below the place of installation must be cordoned off.
The installation surface or mounting fixture needs to be designed in a way that it can take 10 times
its load capacity for at least 1 hour without permanent damaging deformation.
It is also essential that the device is secured by means of a second safety restraint that is
independent of the actual mounting supports when installing it in an elevated position. No part of
the installation must fall down if the main suspension system fails.
Observe all relevant regulations of your country when installing the device.
Acceptance test (in case of industrial/public use):
Before first use and after any significant modifications, the installation (including the electrical connections)
must be inspected by an official expert.
A yearly inspection by an expert is required.
• The rubber feet at the rear of the device can be used to set up the DL-LED107S-UV spotlight on the floor without
mounting brackets.
• The mounting bracket can be used to install the device to the ceiling, the wall or a suitable crossbeam system.
• Install the effect spotlight on the ceiling, the wall or a suitable crossbeam with the mounting bracket. There is an
attachment hole in the mounting bracket for mounting with a screw. The assembly must never swing freely. Use
assembly material suitable for the assembly area and for bearing the effect light load.
• Set the desired inclination angle and tighten the two fastening screws well to the assembly bracket.
• Alternatively to the above described assembly, the two mounting brackets could also be turned so that a standing
base results and the effect spotlight can be set up on the ground. Ensure a safe stance here.
Many provisions and requirements must be observed for commercial or public use. They are only
described here in excerpts. You as the operator are responsible for ensuring that they are complied
with at installation and operation.
22