Connection And Operation - Migatronic SIGMA GALAXY 300 COMPACT/S Betriebsanleitung

Connection and operation

Warning
Read warning notice and
instruction manual carefully prior
to initial operation and save the
information for later use.
Permissible installation
Mains connection
Connect the machine to the correct mains supply. Please read
the type plate (U ) on the rear side of the machine.
1
0
l
1
Connection of shielding gas
Connect the gas hose, which branches off from the back panel
of the welding machine (3), to a gas supply with pressure
regulator (2-6 bar). (Note: Some types of pressure regulators
require an output pressure of more than 2 bar to function
optimally).
One/two gas cylinders can be mounted on the bottle carrier
on the back of the trolley.
Important!
In order to avoid destruction of plugs
and cables, good electric contact is
required when connecting earth cables
and welding hoses to the machine.
2
1
3
Power
F
F F
GAS 2-6 Bar
1. Mains connection
2. Power switch
3. Connection of shielding gas
4. Connection of welding hose
5. Welding hose
6. Connection of cooling hoses
7. Connection of cooling hoses
8. Connection of earth clamp (MIG) or electrode holder
9 Connection of MIG Manager® or push-pull welding hose
(option)
10. Connection of earth clamp (MMA) or electrode holder
11. Cooling liquid level control
12. Refill of cooling liquid
13. Power switch for autotransformer (optional)
14. Activation of autotransformer in standby (optional)
Connection of welding hose
Moreover, a MIG Manager kit (optional) needs to be mounted
with a multiplug on the front of the machine (9) if the
welding hose is equipped with a MIG Manager®.
11