Teuco 543 Installationshandbuch Seite 15

8
INSTALLING THE BUILT-IN BATHTUB
To install the bathtub, follow the above steps and then carry out the following procedures.
Place the bathtub in the prepared installation area and level it using the adjustable feet. THE WEIGHT OF THE BATHTUB
MUST BE SUPPORTED BY THE FEET AND NEVER BY THE PERIMETER EDGE.
Build the perimeter wall so that internally it extends a maximum of 15 mm under the perimeter edge of the tub. THIS IS TO
ALLOW THE BATHTUB TO BE REMOVED FOR FUTURE MAINTENANCE WITHOUT BEING DAMAGED.
MOUNTING THE INSPECTION AND VENTILATION PANEL (for bathtubs with whirlpool)
Separate the inspection and ventilation panel (D) from its frame (T).
Insert the frame (T) into the perimeter wall near the pump and the power unit.
Remount the inspection and ventilation panel onto the frame (T) and fasten it with the screws (Z).
In order to enable maintenance work on the bathtub, disassembly and inspection of the connection between the siphon and
bath waste must be possible.
Art. 543-544-545-546-554:
A full-length removable panel must be provided along the front of the tub, allowing inspection and ventilation of the
whirlpool system. In particular situations, consult the preinstallation data sheet for the product and make the panel
according to the measurements indicated. The panel must be secured semi-permanently (with screws, for example)
in such a way that a tool is needed to remove it, as prescribed by safety standards.
BUILT-IN TUBS ONLY
ART.554
EN
15