Operating Controls; For Your Safety - Bosch GKE 35 BCE PROFESSIONAL Bedienungsanleitung

1 609 929 J52.book Seite 4 Montag, 27. März 2006 10:51 10

Operating Controls

The numbering of the machine elements refers to
the representation of the machine on the graphics
page.
While reading the operating instructions, unfold the
graphics page for the machine and leave it open.
1 Rear handle
2 Lock-off button
3 On/Off switch
4 Oil filler cap
5 Activation lever for kickback brake
(hand guard)
6 Front handle
7 Deactivation mark for kickback brake
8 Nose sprocket
9 Chain guard
10 Chain
11 Chain bar
12 Gripping teeth
13 Tensioning ring (red)
14 Locking knob
15 Cover plate
16 Serial Number
17 Chain tensioning catch
18 Fastening bolt
19 Guide fins for chain bar
20 Oil outlet
21 Symbol for rotation and cutting direction
22 Drive sprocket
23 Chain catch bolt
24 Oil-level indicator
25 Reset button for thermal safety switch
26 Ventilation slots
27 Control indication for kickback brake (red dot)
28 Dust protection cover
Not all of the accessories illustrated or described are
included as standard delivery.

For Your Safety

Warning! Switch off, remove plug from mains
before adjusting cleaning or if the cable is cut,
damaged or entangled.
Caution! Do not touch rotating chain.
Do not operate chain saw near other people,
children or animals. Do not operate chain saw
after drinking alcohol or under the influence of
intoxicating drugs or medication.
21 • 1 609 929 J52 • TMS • 15.03.06
Electrical Safety
Your machine is double insulated for safety and re-
quires no earth connection. The operating voltage is
230 V AC, 50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use approved extension
cables. Extension cords/leads should only be used
if they comply with H07-F types or IEC (60227
IEC 53).
If you want to use an extension cable when operat-
ing your product, only the following cable dimen-
sions should be used:
2
– 1.0 mm : max length 40 m
2
– 1.5 mm : max length 60 m
2
– 2.5 mm : max length 100 m
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
The couplings of connection leads must be pro-
tected against splashes and the coupling sockets on
the leads must be made of rubber or coated with
rubber.
Fixing means for the connection leads must be
used.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if
in perfect condition.
If the supply cord is damaged, it must be replaced by
a Bosch Service Centre.
Assembly/Tensioning Chain
(see figure
Do not connect the chain saw to mains be-
fore it is completely assembled.
Always use gloves when handling the chain.
Chain and chain bar Assembly
1. Unpack all parts carefully.
2. Align the two assembly arrows
sioning ring 13 and cover plate 15.
15
13
3. Place the chain saw on any suitable flat surface.
Use only genuine Bosch chains designed for
chainbars with 1.3 mm groove (guage).
English - 4
)
A
on the ten-