Purpose Of This Manual - BATTIPAV VIP 845 Bedienungsanleitung

GB
"TRANSLATION OF THE ORIGINAL
INSTRUCTIONS"

PURPOSE OF THIS MANUAL

This manual is an integral part of the machine.
It was produced by BATTIPAV S.R.L. to provide
those authorised to work with the machine with the
information required for its foreseeable lifespan.
Before starting to use this machine read the safety
chapter carefully.
Each machine is subjected to a series of tests and
carefully checked before leaving our factory.
BATTIPAV S.R.L. is constantly striving to develop
their machines and therefore reserves the right to
make any change without prior notice. Therefore, no
claims may be made on the basis of the data and
illustrations contained in this manual.
SaFety iNForMatioN
• The manufacturer accepts no responsibility where
the VIP cutter is used with any tools other than those
specified in the "RECOMMENDED USE" paragraph.
DO NOT USE WOODEN DISCS.
DO NOT USE DRY-CUTTING DISCS.
• VIP is made to operate exclusively under the
conditions indicated under "TYPE OF OPERATION
ALLOWED", in the "TECHNICAL DATA" paragraph.
• During cutting
the machine
• VIP is not
with a
16
operations,
to rest as indicated.
made for
continuous
CAUTION
The following steps are advisable:
• Let the motor run slowly, preventing the disc
from getting locked.
• Ensure that the piece to be cut is properly
supported by the tile clamp.
• Check before each cut that the adjustment knobs
for the cutting angle are tightened.
CAUTION
THE MACHINE IS NOT INTENDED FOR USE IN AN
EXPLOSIvE ENvIRONMENT
CAUTION
aLwayS uSe iNdiViduaL ProtectioN deViceS
to reduce the riSkS cauSed By work. NeVer
START THE MACHINE WHEN THE CUTTING TOOL
iS MoViNG; wait For it to StoP.
Warning! When using electric tools, following
safety precautions should always be followed to
reduce the risk of fire, electric shock and personal
injuries. Read and follow all these instructions
before attempting to operate this product and save
them with care!
SAvE THESE INSTRUCTIONS WITH CARE.
keep your work area perfectly clean
• Cluttered areas invite injuries.
Consider work area environment
• Don't expose tools to rain.
allow
• Don't use tools in damp or wet locations. Keep
work area well lit.
use
• Don't use tools in presence of flammable liquids
load.
or gases.
Guard against electric shocks
• Prevent body contact with grounded surfaces.
keep children away!
• Do not let third parties contact tool or extension
cord. All visitors should be kept away from work
area.
Battipav srl