Trouble Shooting - T+A V10 Betriebsanleitung

Many problems have
correspondingly simple solution. The following section
describes a few difficulties you may encounter, and the
measures you need to take to cure them. If you find it
impossible to solve a problem with the help of these
notes please disconnect the unit from the mains and ask
your authorised  specialist dealer for advice.
Notes on the remote control system
Changing the remote control address:
Nowadays virtually all modern Hi-Fi and video equipment
can be controlled using an infra-red remote control
system. Unfortunately only a limited number of infra-red
codes are available, and they are used by a vast range of
manufacturers.
The result of this situation is that mutual interference may
occur if equipment made by different manufacturers is
used together in the same household, as the machines
may operate using the same remote control code. A typical
problem might be that your Hi-Fi system responds to the
remote control handset supplied with your television or
video recorder.
If you encounter this problem, your B valve amplifier
can be changed to a different remote control level using
special software. Please contact your specialist B
dealer for advice on this matter.
If you have this change carried out, the remote control
level of the F10 handset will also have to be changed to
match the level of the Hi-Fi unit.
To change the remote control level hold the v
button and the numeric button ó
simultaneously. After about 10 seconds the LED will flash.
Now press the numeric button ñ
remote control level or ò ò for the alternative level. ò ò
The LED will now go out to confirm that the switch has
taken place.

Trouble shooting

a simple cause and
v
v v
ó pressed in
ó ó
ñ to set the normal
ñ ñ
a
Problem: Machine does not switch on.
Cause 1: Mains lead not plugged in correctly.
Remedy: Check connection, push connector in
firmly.
Cause 2: Mains switch on the back panel (in the
mains socket) not switched on.
Remedy: Switch the mains switch on.
Cause 3: Mains fuse burned out.
Remedy: Have the mains fuse in the mains input
socket
specialist workshop. The rating of the
replacement fuse must agree with the
specification printed on the unit.
Problem: The
commands.
Cause: Static discharge or powerful interference
(e. g.
processor memory.
Remedy: Disconnect
1 minute and re-connect. Switch unit on
again.
Problem: Machine responds correctly to manual
operation of the buttons, but does not
respond to remote control commands.
Cause 1: Incorrectly
batteries in the remote control handset.
Remedy: Re-install batteries correctly or fit new
ones.
Cause 2: If you are using the F1 remote control
handset:
F1 remote control handset not set to Hi-Fi
mode.
Remedy: Switch F1 to Hi-Fi mode by pressing the
 rocker. 
 
Cause 3: Inefficient receiver position.
Remedy: Make sure that there is direct visual
contact
receiver (on the screen of the V10) and
the remote control transmitter (handset).
Note
problems,
Maximum range between transmitter and
receiver approx. 8 metres.
Position the V10 in such a way that it is
not subjected to direct sunlight or strong
artificial lighting. Fluorescent and energy-
saving lamps are powerful sources of
interference.
40
replaced by an
unit does not respond
lightning) have corrupted
mains plug, wait
inserted batteries
between the remote
that glass doors can
and should be
authorised
to
the
about
or flat
control
cause
avoided.