Before Use; Operation; Preparing For Use - Hilti TE 700-AVR Bedienungsanleitung

6 Before use

CAUTION
Check the insert tool for damage or uneven wear each
time before use.
6.1 Fitting and adjusting the side grip 2
1. Disconnect the mains plug from the power outlet.
2. Release the side grip clamping band by turning the
knob.

7 Operation

DANGER
Always hold the power tool securely with both hands
on the grips provided. Keep the grips dry, clean and
free from oil and grease.

7.1 Preparing for use

CAUTION
Wear protective gloves when changing insert tools
as the insert tools get hot through use and they may
have sharp edges.
7.1.1 Fitting the insert tool 3
NOTE
The chisel can be adjusted to 24 different positions
(in 15° increments). This ensures that flat chisels and
shaped chisels can always be set to the optimum working
position.
1. Disconnect the mains plug from the power outlet.
2. Check that the connection end of the chisel is clean
and lightly greased. Clean it and grease it if neces-
sary.
3. Check that the sealing lip of the dust shield is clean
and in good condition. Clean the dust shield if ne-
cessary or replace it if the sealing lip is found to be
damaged (please refer to the "Care and mainten-
ance" section).
4. Push the chisel into the chuck and rotate it while
applying slight pressure until it engages in the guide
grooves.
3. Relax the tension on the side grip (clamping band)
and slide it over the chuck and onto the shank.
4. Pivot the side grip into the desired position.
5. Secure the side grip by tightening the knob.
6.2 Unlocking the power tool (theft protection
system)
See section "Operation / TPS Theft Protection System
(optional)".
6.3 Use of extension cords and generators or
transformers
See section "Description / use of extension cords".
5. Push the chisel further into the chuck until it is heard
to engage.
6. Check that the chisel has engaged correctly by
pulling it.
7. In order to position the tool, turn the function selector
switch to the 'Turn chisel' position.
8. Rotate the chisel to the desired position.
9. In order to position the tool, turn the function selector
switch to the 'Lock chisel' position.
10. Turn the chisel until it locks in place (24 catch
positions per revolution).
7.1.2 Removing the chisel 4
DANGER
Do not lay a hot insert tool down on flammable ma-
terials. This could cause the material to ignite, resulting
in a fire.
1. Disconnect the mains plug from the power outlet.
2. Open the chuck by pulling back the locking sleeve.
3. Pull the chisel out of the chuck.
7.2 Operation
WARNING
If the power tool starts without pressing the on/off
switch when the supply cord is plugged back in after
unplugging, the power tool must be brought to Hilti
Service immediately.
WARNING
Unplug the supply cord if the on/off switch is found
to be faulty.
en
23