Standalone Configuration; Using The Standalone Web Interface - e:cue Butler XT2 Bedienungsanleitung

d
0 8
...
Crd
EP
EC
SEr
S
Loader mode
Display
LOAd

Standalone configuration

For a complete overview of other functions like clustering and assignments of Ac-
tions and programming of shows see the System Manual for the Lighting Applica-
tion Suite, available for download from www.traxontechnologies.com for free.
The Butler XT2 can either be configured in standalone mode without the Lighting
Application Suite and only with a web browser and a PC, or it can be setup in online
mode with the Lighting Application Suite. Configuration in standalone mode is most
recommended when the Butler XT2 has his factory settings.

Using the standalone web interface

You can set the network parameters of the Butler XT2 without any other system
using a standard web browser on any PC or PC-like system.
DMX modus.
0...8 für number of parallel running cuelists.
SD card error, no card inserted, check the SD card. Reset with
system button.
e:bus overload due to over current or power failure. This can
happen when connecting devices with high inrush current during
operation. Check the e:bus for shortcuts and the power supply for
correct supply voltage. Reset with the system button.
Configuration of the e:bus failed. If repeated please contact the
e:cue service.
The serial number could not be read. Rest the system. If the error
happens again, please contact the e:cue service.
A blinking S indicates standby. The Butler XT2 is in standalone
mode, but no cuelists are running or no cuelists available.
Description
The Butler XT2 is in loader mode and waits for a firmware update.
Setup Manual - Butler XT2
15