Connector Removal - WAGO LON FTT 753-648 Bedienungsanleitung

WAGO-I/O-SYSTEM 753
®
753-648 LON FTT Module
Pos: 61.17 /Serie 753 (WAGO-I/O-SYSTEM)/Montieren/Lösen des Steckers von der Busklemme Serie 753 @ 4\mod_1240393485109_21.doc @ 31214 @ 3 @ 1
4.3.2

Connector Removal

1. Remove the connector from the I/O module by pulling the orange pull tab
on the connector toward the top of the module.
Figure 19: Pulling the pull tab
The connector detaches from the module.
Figure 20: Removing the connector without tools
2. Alternatively, you can also use a standard screwdriver at the position shown
(in the figure below) to remove the connector.
Figure 21: Removing the connector using a screwdriver
Pos: 62 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Manual
V1.0.0
Mounting 33