Cleaning The Appliance - Philips HD6103 Bedienungsanleitung

EnglisH
10
preclean function
This appliance is equipped with a PreClean function, which allows you to soak the inner bowl with
hot water and washing-up liquid to make cleaning easier.
Make sure you have removed the oil or fat from the inner bowl before you use this function.
1 Fill the inner bowl with cold water up to three quarters of its capacity and add some
washing-up liquid. (Fig. 15)
 Put the plug in the wall socket.
 Set the temperature control to the PreClean function. (Fig. 7)
The water is heated to a temperature just below boiling point.
,
 Unplug the appliance after 20-30 minutes.
5 Pour the water out of the inner bowl and clean it as described below.

cleaning the appliance

1 Clean the housing of the fryer with a moist cloth (with some washing-up liquid) and/or
kitchen paper.
You can clean the timer with a moist cloth.
 Clean the bowl, the lid and the frying basket with hot water and some washing-up liquid,
rinse them with fresh water and dry them thoroughly.
The lid and the frying basket can also be cleaned in the dishwasher.
Make sure that all parts are dry before you fill the fryer with oil or fat.
storage
1 Let the oil or fat cool down for at least 4 hours before you clean or move the fryer.
 Put all parts back into/onto the fryer and close the lid.
 Push the cord into the cord storage compartment. (Fig. 16)
 Lift the fryer by its handles and store it (Fig. 17).
Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 18).
- Batteries contain substances that may pollute the environment. Do not throw away batteries
with the normal household waste, but dispose of them at an official collection point for
batteries. Always remove the timer battery (HD6104 only) before you discard and hand in the
timer at an official collection point.
Removing the timer battery (HD6104 only)
1 Use a small flat-blade screwdriver to remove the back of the timer (Fig. 19).
 Remove the battery.