Filter Installation; Care And Cleaning - AEG PROSOURCEGYB00416ST Installations- Und Bedienungsanleitung

30 www.aeg.com
2.6 Pressure safety valve
installation
• Leave the outlet of the pressure-relief
device open to the atmosphere so
water may drip from the discharge
pipe.
• The pressure safety valve is available
in two different types (8 bar and 10
bar). Make sure you install the correct
pressure safety valve, based on
national and/or local regulations.

2.7 Filter installation

• A filter can be installed to reduce the
hardness and/or chlorine values. The
relevant water supplier can provide
information on the hardness and
chlorine value. AEG recommends
using a filter if the hardness is more
than 10 °DH.
• For hygiene reasons, the filter system
must be flushed before using for the
first time. Refer to the filter manual
for information about flushing the
filter.
• The filter installation kit and
replacement water filter cartridges
can be ordered online at shop.aeg.
com, part code: 9029795565.
2.8 Use
WARNING!
Risk of scalding!
• Water can be very hot. Always turn
on the tap carefully to prevent
splashing.
• Only open the tap when placed
directly above the sink to prevent
splashing.
• Only use tap water in products which
are (boiling) water resistant. Not all
materials are boiling water resistant
and this can lead to permanent
deformation of the product or to
serious injury.
• Wear protective equipment like oven
gloves or pot-holders when you fill
products with boiling water.
• Use the appliance only for its
intended use as described in this
manual.
• Make sure the plug of the boiler and
the power cable are not damaged
when using the appliance. Contact
the manufacturer or an electrician if
parts are damaged.
• Clean the appliance regularly
according to the instructions in this
manual.
• Unauthorized alterations to the
appliance and technical
modifications are not permitted.

2.9 Care and cleaning

• The boiler and plug must not be
directly or indirectly sprayed with
water when cleaning.
• Clean the appliance with a dry,
lint-free cloth. Do not use detergents
or other solvents to clean the
appliance.
2.10 Repair, disassemble,
discard
• Only qualified, certified personnel
may repair, disassemble or discard
the appliance. Disconnect the
appliance from the power supply
when you repair, disassemble or
discard the appliance.
• Use only original spare parts. The use
of other parts will result in voiding of
the warranty and the CE
identification, and could lead to
injuries.
• Recycle the materials with a recycling
symbol. Put the packaging in
applicable containers to recycle it.
Help protect the environment and
human health and to recycle waste of
electrical and electronic appliances.
Do not discard appliances marked
with the [symbol] symbol with the
household waste. Return the product
to your local recycling facility or
contact your municipal office.