Use; Preparing The Carpet; Preparing The Device/Fi Lling The Fresh Water Tank - DS Produkte Cleanmaxx VC9388 Gebrauchsanleitung

Use

Preparing the carpet

1. Thoroughly vacuum clean the carpet to be treated with a vacuum cleaner. Use a brush
adapter for this (if possible).
2. If possible, remove all furniture from the carpet. Place a plastic tarp under or around
the legs of large pieces of furniture that can't be moved aside and only remove the
tarp once the carpet is completely dry after cleaning. Otherwise the wet carpet could
damage the legs.
3. Check the carpet's colour-fastness. Dip a piece of white fabric in the enclosed clean-
ing solution (see section "Preparing the device/fi lling the fresh water tank") and care-
fully rub it on a hidden part of the carpet. If the white fabric does not discolour, you
can clean the carpet with the device. For multicoloured carpets, test every colour for
colour-fastness.
Preparing the device/fi lling the fresh water tank
ATTENTION!
❐ Only fi ll the fresh water tank with the enclosed cleaner or with commercially-available
carpet cleaners for carpet washers.
❐ Do not use any high-foaming cleaners as an excessive amount of foam impairs the
functioning of the device.
1. Hold the fresh water tank (3) by the handle and press the
release button (2). The tank will be released from the lock-
ing mechanism.
2. Take the fresh water tank out of the device.
3. Unscrew the tank cap and fi ll it with carpet cleaner. Please
follow the dosage instructions for the cleaner.
4. Fill the fresh water tank with warm water (max. 40 °C) up to
the Max mark. Then put the cap back on the tank.
5. Mount the fresh water tank in the midsection. To do this, fi rst
insert the rubber connecting piece on the bottom of the
in the ring of the main unit. Then press the tank against the
top part of the midsection until it locks into place.
19
tank