Dry Ironing; After Ironing; Cleaning And Maintenance - Ariete Duetto 6437 Bedienungsanleitungen

the spray button repeatedly (Fig. 15).

Dry ironing

Plug into the mains socket. Set the temperature control knob (M) depending on the type of fabric to be ironed. Wait a few
minutes for the soleplate to reach the set temperature. Do not press the steam button.
vertical ironing
This special ironing procedure serves to remove creases from curtains, fabrics, etc. Set the ironing temperature by turning
the adjustment knob (M) past the symbol (
the steam button. If the temperature lamp is on, do not press the steam button more than three times in a row.
Warning
Do not iron fabrics held by other people.

After ironing

Set the temperature control knob (M) to "min".
unplug it from the electric outlet. Let the iron cool down on its stand (E). Empty the tank: open the tank filling cover (I),
overturn the iron and let water drain (Fig. 21).
Warning
Let the iron cool down before emptying the tank: danger of burns.
Store the power cord in the cord storage compartment (B). Put back the cable connecting the iron to the tank in the cord
storage compartment (Y). Let the iron cool down on its stand, taking care not to touch the power cables and connection with
the hot parts of the appliance.
suggesTIOns
Divide the articles to be ironed according to the types of material: wool with wool, cotton with cotton, etc.
Because the iron heats up much more quickly than it cools down, it is advisable to start with those fabrics which require
lower temperatures and move on to those which require progressively higher temperatures. If the material is made up of
more than one type of fibre, always set the temperature to the fibre which requires less heat. For example, if the material
is made up of 70% synthetics and 30% cotton, set the temperature control to position (•) (see table) without steam, that is,
the temperature for synthetic fabrics.
If you do not know the composition of the article to be ironed, choose a part of the article which will not be seen. Do a test
ironing on this part to establish the appropriate temperature (always start with a relatively low temperature and work up until
the ideal temperature is reached). Pure (100%) wool articles can be ironed with the iron set to one of the steam positions.
To avoid pure wool, silk and synthetic materials becoming shiny, it makes good sense to iron them on the reverse side. For
other materials, especially velvet, which can become shiny very easily, cover them with a cloth and iron in one direction only,
using light pressure. The iron must be kept constantly moving over the fabric.
Label Ironing Kind of fabric
instructions
Synthetic fabrics:
Acetate
Acrylic
Viscose
Poliammide (Nylon)
Viscose (Rayon)
Silk
Wool
Cotton
Linen
The mark on the label means do not iron

cleAnIng AnD MAInTenAnce

Warning!
Before cleaning, always disconnect the plug from the power point and allow the iron to cool down on its stand grille.
18
•••
). Put the curtain or fabric in the position you want to iron it vertically and press
Thermostat
•
••
•••