Overview - Abus Smartvest Bedienungsanleitung

Overview

Status display
Three different symbols are used to represent the different
Smartvest statuses in the status display. The current status is
marked in colour, with the relevant text shown below. You can
change the status by dragging to the left or right or, alternatively,
by tapping the desired status.
Smartvest is internally armed
The internal arming is pre-programmed as perimeter
protection ex-works. This means that opening
detectors do trigger an alarm whereas motion
detectors do not. This means you can move around
freely inside the house (internally) without triggering
an alarm. However, the opening detector triggers an
alarm if anyone enters the premises from the outside.
Recommended application: Set the Smartvest to
internally armed before you go to bed.
Smartvest is unarmed (ready to arm)
In this status, the system is not live. Notifications from
most sensors do not trigger an alarm. The only
exception is the smoke alarm device which, for your
own safety, always triggers an alarm irrespective of
the system status. In addition, an alarm is triggered if
any of the components sends a sabotage message.
Recommended application: Set the Smartvest to
disarmed when you come home.
Smartvest is armed
The arming is pre-programmed as full protection ex-
works. This means that all sensors trigger an alarm.
Recommended application: Set the Smartvest to
armed when you leave the house and there is no-one
else at home.
Note
When pairing components, standard values are
automatically set for the active status. Should you
wish to alter the settings for the status in question,
you can find the settings under point 5.5 – Advanced
settings/Status configuration.
32
English