H) System Queries - Renkforce Matrix Beam Moving Head 9 x 12 W Bedienungsanleitung

Specification of the basic settings
In this menu, you can specify the basic settings to be loaded after the system starts.
• In the menu, select Advanced Setup and push the ENTER (11) button.
• Select the menu item Home Position Set with the buttons UP (10) and DOWN (13) and push the button ENTER (11).
• Enter the password 018 with the UP (10) and DOWN (13) buttons and push the ENTER (11) button.
• Select the desired basic settings with the UP (10) or DOWN (13) buttons and confirm each selection with the
ENTER (11) button:
- Pan = swivel position
- Tilt = tilt position
- Red = maximum brightness red
- Green = maximum brightness green
- Blue = maximum brightness blue
- White = maximum brightness white
Setting of the microphone sensitivity
see Sound-to-Light mode
Setting of the maximum movement speed
• In the menu, select Advanced Setup and push the ENTER (11) button.
• Select the menu item XY MAX Speed with the UP (10) and DOWN (13) buttons.
• Push the button ENTER (11).
• Set the value for the maximum movement speed for pan and tilt with the UP (10) and DOWN (13) buttons
(000 = maximum / 254 = minimum) and confirm input with the ENTER (11) button:

h) System queries

• In the menu, select System State and push the ENTER (11) button.
• The display (8) shows the relevant data:
- On Time = Operating time since the last activation
- Total Time = Total operating time
- Current Mode = Set operating mode
- Temperature = Operating temperature of the device
- Software Version = version of the software
41