Use And Operation - Klarstein 10030014 Bedienungsanleitung

Installation
• This wine cooler is designed to be free standing only, and should not be recessed or built-in.
• Allow 5 inches of space between the back and sides of the wine cooler, which allows the proper air venti-
lation. Adjust the feet to keep the wine cooler level. Locate the wine cooler away from direct sunlight and
sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources
may increase electrical consumption. Ambient temperature below 5°C or above 32°C will hinder the perfor-
mance of this appliance.
• Depending on the location of the appliance, the direction of the door opens can be changed.
• This unit is not designed for use in a garage or any other outside installation.
• Avoid locating the wine cooler in moist areas.
• Plug the wine cooler into dedicated, properly installed-grounded wall outlet. Do not under any circumstan-
ces cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician or an authorized service center.
• This unit is not designed to be installed in an RV or used with an inverter.
• After plugging the wine cooler into a wall outlet, turn the unit on and allow the unit to cool down for 3-4
hours under before placing wine bottles or beverages in the appliance.
• Keep ventilation openings in the appliance enclosure, clear of obstruction.
Control Panel and Buttons
Light button: To turn the inner light on or off.
Power button: To control the appliance on or off.
Plus button: Used to increase the set temperature by 1 °C or 1 °F
Minus button: Used to lower the set temperature by 1 °C or 1 °F

Use and Operation

12