Electrical Connection; The First Use - Blomberg WAF 1320 Bedienungsanleitung

Fastening the hose holder:
1. Pull the holder included in delivery
over the end of the hose.
2. Hand the drain hose with the holder
over the edge of the basin or tub and
secure it from sliding off – e.g. by fas-
tening it with a chain around the wa-
ter tap.
Permanent connection to a siphon trap:
A
A qualified plumber should attach the
hose to prevent the hose from slipping
off. There is a risk of flooding.

Electrical connection

Connect the appliance to a properly in-
stalled earthed outlet, which is protected
by a fuse of adequate capacity.
Important:
• The connection must conform to the
applicable regulations in your country
and those set by your electricity
board.
• The power cable plug must be accessi-
ble after installation.
• Voltage and rated fuse protection is
specified on the type plate located on
the back of the loading door.
• The stated voltage must match with
your mains voltage.
• Connection by extension cables or
trailing sockets is not permitted.
B
A damaged power cable must be re-
placed by a qualified electrician.
Unless the appliance has been re-
paired it must not be operated! Risk of
electric shock!

The First Use

3
Refer to the section on "Troubleshoot-
ing" if the machine can't be switched
on.
To flush out any remaining test water, the
first washing cycle should be run without
any laundry.
1. Open water tap fully. Check if hoses
are firmly attached.
2. Check that the drum is completely
empty; close the loading door.
3. Add a small amount of detergent to
the second compartment; close deter-
gent dispensing drawer.
4. Press >On/Off<18 button. Some infor-
mationa appears in the display after a
few seconds.
5. Set programme selector to >Hot wash/
Coloured 95 °C< (see "Programmes").
The spin speed indicator should be set
to maximum speed – if necessary press
the >Spin< 21 button.
6. Press >Start/Pause< 2 0 button.
A
In case of abnormal sounds or leakage
of water: Press >On/Off<18 button,
close water tap and pull mains plug
out of the socket. Check to see that all
transit bars have been removed and
the hoses are properly connected.
34