Klarstein 10029819 Einbauanleitung Seite 15

• Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the unit not to perform properly.
• Plug the Wine Cooler into an exclusive, easily accessible plug socket. Any questions concerning power and/
or earthing should be directed towards a qualified electrician or an authorized products service centre.
• To prevent the appliance from heating up, ensure that an adequate ventilation gap is retained and install a
suitable thermal insulation panel. An adequate flow of air to and from the cooling system must be ensured.
• The appliance must be installed to all electrical, plumbing, water and drain connections in
Built-in Cabinet Instructions
The wine cooler door seals the installed unit almost completely, so an air vent must be provided in the base of
the housing. Warmed air must be conducted via the ventilation shaft to the rear wall of the housing and then
expelled upwards. The ventilation channels should measure at least 200 square centimeters in cross-section.
1. Remove the door gasket on the side you wish to install the handle - you can see two designated holes for
handle installation.
2. Install the handle tightly as shown above with two screws, lock washers and flat washers provided. WAR-
NING: To ensure the proper functioning of the appliance, air vents should never be blocked or covered.
Attention
• Store wine in sealed bottles.
• Do not overload the cabinet.
• Do not open the door unless necessary.
• Do not cover shelves with aluminum foil or any other shelf material which may prevent air circulation.
• Should the wine cooler be left empty for long periods it is suggested that the appliance is unplugged, and
after careful cleaning, leave the door ajar to allow air to circulate inside the cabinet in order to avoid possible
condensation, mold or odors forming.
• Replace the door gasket.
Installation of Your Wine Cooler Built-in
• The appliance is designed to be built in between (Door) kitchen cabinets and is supplied with adjustable feet
that can be altered to fit various worktop heights. This wine cooler is fully compatible with any 600mm
deep kitchen unit.
• The air vent at the front of the appliance must never be covered or blocked in any way.
• Avoid locating the unit in damp areas.
15