Deleting Measured Values - Bosch PLR 25 Originalbetriebsanleitung

OBJ_BUCH-2646-002.book Page 26 Monday, June 27, 2016 12:58 PM
26 | English

Deleting Measured Values

Briefly pressing the On/Off button 8 will delete the most recently acquired individual
measured value in all measuring functions. Repeatedly pressing the button briefly will
delete the individual measured values in reverse order.
Adding/Subtracting Values
Measured values or end results can be added or subtracted.
Adding Values
The following example describes the addition of areas:
Measure an area as described in section "Area Measurement", see page 24.
Press the button 7 [+]. The calculated area is shown in the cen-
tre of the display.
2.650 m
5.301 m
14.049 m
2
Press the measuring button 4 to start another area measure-
ment. Measure the area as described in section "Area Measure-
14.049 m
ment", see page 24. To complete the addition, press the meas-
2
+84.295 m uring button 4. To add more measured values, again press
2
button 7 [+] etc.
98.345 m
2
Subtracting Values
To subtract values, press button 2 [–]. The subsequent steps are the same as for
"Adding Values".
List of the Last Measured Values/Calculations
The measuring tool stores the last 10 measured values and their calculations and dis-
plays them in reverse order (most recent measured value/most recent calculation
first).
Press button 6 to display the measured-value list.
Deleting Measured Values in the Measured-Value List
Briefly pressing the On/Off button 8 will delete the currently displayed measured value.
Simultaneously pressing button 6 and the On/Off button 8 will delete all measured
values in the measured-value list.
1 609 92A 23Y | (27.6.16) Bosch Power Tools