Busch-Jaeger 6411 U-101 Betriebsanleitung Seite 76

Brightness sensor
c. Setting (for operating element 6430 or 6066)
Please proceed as follows to set the threshold value for
the brightness sensor irrespective of the current
brightness:
● Ensure that the brightness sensor is attached at the
planned position and uncovered.
● Change the position of the adjustment knob
– to the right if the sunshade function is to
be actuated at a low brightness value,
– to the left if the sunshade function is
only to be actuated at high brightness
value.
● Saving the current brightness as desired threshold
value for the brightness sensor:
If the current brightness is to be stored as a threshold
value, the adjustment knob (Fig. 5, Pos. 7) must first of
all be turned to the minimum value (all the way to the
right). Wait for a few seconds and then turn it to the
ENG
Fig. 10
76