Operation; Maintenance - Tout Terrain Mule Bedienungsanleitung

5. Attaching the trailer to the bike: The quick-
release of the cardan joint must be open and
the coupling parts need to be clean. The cardan
joint is pushed over the coupling until it is
completely plugged in (the cardan joint nearly
contacts the seat post coupling now). The easi-
est this can be done is if the trailer stands on
its stand and the bicycle is led to the coupling
with one hand, while the other hand aligns
the coupling to the bicycle. Make sure that the
Singletrailer hangs straight behind the bike.
Proceed as follow:
a) Always stick the fastening bolt through
the coupling.
b) The quick-release fastener needs to be
attached securely and closed accurately.
5. a

OPERATION

➔ Permissible maximum weight 45 kg.
➔ The maximum cargo load is 38kg.
➔ Always secure your load.
➔ Always make sure that the quick releases are
tightened & the wheel is properly engaged.

MAINTENANcE

Examine the wearing parts in regular intervals
and/or let your dealer accomplish maintenance
work if necessary. Regular maintenance rates
can difficulty be indicated, as the wear strongly
depends upon frequency of use and terrain.
Parts, which should be examined before
each trip for wear and function:
➔ tread
➔ air pressure of the wheel
➔ spoke tension and rotation of the wheel
➔ function of the shock
➔ correct & secure fit of the wheel
Warning: It is important that the wheel
engages completely and you cannot pull it out!
You recognize this by the fact that the pin
completely disappears in the axle center!
5. b
TuNING susPENsION
In the air chamber a different air pressure must
be adjusted depending upon the cargo weight.
The damping (red adjusting screw) should always
be adjusted as weakly as possible, so that the
shock releases quickly but without striking
through when releasing. If you adjust the suspen-
sion travel (road or off-road position) note that
shock air pressure and damping also possibly must
be adapted. Please also read the separate manual
for the shock.
The road position requires slightly lower air
pressure.
AssEMBly INsTRucTIONs TO
ATTAcH THE MuDGuARD
Important: There are no tools required to as-
semble the mudguard to the trailer. It is easier
to assemble the mudguard if you remove the
wheel. Please check before every ride the secu-
re fit of the quick releases.
1. Release the Nut of the quick release of the
shock. Slide the mudguard over the axle of
the quick release
1. a)
2. Assemble the additional quick release with
the spacer in the open slot of the shock mount.
The spacer is avoids deformation of the shock
mount.
2.
1. b)