Troubleshooting - h.koenig BW1880 Bedienungsanleitung

Trouble
The tap does not
work / can't pour
beer out
Too much bubble
pouring out
Beer flows out too
slowly
ENVIRONMENT
CAUTION :
Do not dispose of this product as it has with other household products.
There is a separation of this waste product into communities, you will need
to inform your local authorities about the places where you can return this
product. In fact, electrical and electronic products contain hazardous
substances that have harmful effects on the environment or human health
and should be recycled. The symbol here indicates that electrical and
electronic equipment should be chosen carefully, a wheeled waste
container is marked with a cross.
Manufactured and imported : Adeva SAS 8 rue Marc Seguin 77290 Mitry-Mory FRANCE
www.hkoenig.com - contact@hkoenig.com - Tel 01 64 67 00 01
Cause
1. The pouring tube is in poor
connection or CO2 supplying is
cut off
2. No keg or no beer in the keg;
3. No gas in the CO2 cartridge
4. The CO2 pressure regulator
knob is close
1. Use a wrong way to pour beer
out
2. The beer temp is high (better
at 3-5C)
3. The keg is shaken before
usage
4. Almost no beer in the keg
5. Too much pressure in the keg
1. Inside CO2 pressure isn't
high enough
2. The connection tube or
pouring tube has leakage

Troubleshooting

1. Well connect the pouring
tube and CO2 supplying
2. Change a new keg
3. Change a new CO2
cartridge
4. Turn the CO2 pressure
regulator knob on "+" position
1. Use the right way to pour
beer out
2. Cool the beer down to 3-5C
3. Put the beer keg aside a
while till no bubble inside
4. Change a new keg
5. Adjust the pressure knob to
"-" direction to decrease the
pressure or close the knob
1. Adjust the pressure knob to
release much CO2 pressure
or replace a new one.
2. Check whether the tube is
leakage or not, if so replace
the tube