Using Your Microphone - AKG C 1000 S Bedienungsanleitung

2 Interfacing
2.3 Phantom
Powering
Fig. 4: Connecting
to a balanced input
with phantom
power.
Refer to fig. 4.
Note:

3 Using Your Microphone

3.1 Installing the
PPC 1000 or
PB 1000
Fig. 5: Installing the
PPC 1000/PB 1000.
Refer to fig. 5.
Important!
18
1. Use an XLR cable (e.g., the optional MK 9/10 from AKG) to
connect the microphone to a balanced XLR input with
phantom power.
2. Switch the phantom power on. (Refer to the instruction
manual of the unit to which you connected your C 1000 S.)
The microphone will automatically switch from battery
mode to phantom power mode and deactivate the
BATT CHECK LED.
Therefore, you do not need to remove the battery when
phantom powering the microphone. The BATT CHECK LED
will remain dark in phantom power mode.
1. Unscrew the wire-mesh cap.
Slip the attachment (1) on the microphone capsule (2) to the
stop, slightly turning the attachment (1) as you push it home.
When installing or removing the PPC 1000 or PB 1000
attachment, make sure to grip the capsule (2) and rubber