SMART SRS-LYNC-XS Bedienungsanleitung Seite 13

ONLINE SETUP GUIDE
SMART ROOM SYSTEM FOR MICROSOFT LYNC
e. Select your time zone, specify the current date and time, and then click Next.
IMPORTANT
You must specify the correct date and time. If the room system's date and time are different
than the Lync and Microsoft Exchange servers' dates and times, the room system is unable
to connect to the servers.
The Lync appliance restarts one or more times. When the basic configuration process is
complete, a screen prompting for the administrator account's password appears.
NOTE
After the Lync appliance shuts down and starts again for the first time, it might prompt you
for a password or it might log in by itself. In either case the Lync appliance will shut down
and start again.
f. Continue to Procedure 4: Logging on and configuring the displays below.
Procedure 4: Logging on and configuring the displays
To log on and configure the displays
a. Type the room system administrator account's password, and then press ENTER.
The SMART end user license agreement appears.
b. Read the SMART end user license agreement, and then click Accept.
The Conferencing Microphone Configuration dialog box appears.
c. Select Use the table microphone, and then click OK.
IMPORTANT
You are unable to change this setting later, so ensure you select the correct option.
d. If the First things first dialog box appears, select Use recommended settings, and then click
Accept.
A dialog box prompting you to check the display settings appears.
e. In the dialog box prompting you to check the display settings, click OK.
Another dialog box appears, and Control Panel opens.
EN-11 smarttech.com/kb/170608