Standby Mode; Starting And Shutting Down The Ups System; Starting The Ups System - Online USV XANTO S 700 Benutzerhandbuch

O P E R A T I O N

4.2.4 Standby mode

If the UPS system is shut down, however, the plug remains in the
outlet, the UPS system will continue to run in standby mode. The
display is switched off, which indicates that no current is available for
the connected load. The batteries are charged, if necessary and the
communication slot is supplied with power.
If the mains power fails and the output power is switched off due to
flat batteries or an internal fault of the UPS system, the UPS system
switches with a warning signal to standby mode. It continues to
supply the communication slot for up to 1.5 hours (depending on
settings) or until the battery voltage sinks below 1.75V per cell.
The condition which occurs first applies in each case.
If the mains power fails while the UPS system is in standby mode,
the power supply of the controller switches off after approximately
10 seconds.
If the UPS system is waiting for commands and the power fails,
the device and the power supply of the controller switch off after
approximately 30 seconds.

4.3 Starting and shutting down the UPS system

4.3.1 Starting the UPS system

1. Check whether the power cable of the UPS system is plugged
in.
2. If you haven't done so already, switch on the mains power
supply for the circuit that the UPS system is connected to.
The display on the front side of the UPS system lights up and
shows the status "UPS initialising ...".
3. Make sure that the UPS system switches to standby mode
("UPS on standby").
4. Press the
ond. The status indication on the display switches to "UPS
starting...".
XS700-XS3000_manual_ger_eng_it_V1.1.0.doc
button on the UPS system for at least one sec-
104 / 222
...........................................................
R. Kistler