Pairing The Wireless Subwoofer With The Main Unit; Automatic Pairing; Manual Pairing; General Operation - Blaupunkt LS 2400 Bedienungsanleitung

Pairing the Wireless Subwoofer with the Main Unit

• Automatic pairing

The subwoofer and soundbar will automatically pair when both units are plugged into the mains
sockets and turned on. No cable is needed for connecting the two units.
• When the subwoofer is pairing with the main unit, the Pair Indicator will flash fast.
• When the subwoofer is paired with the main unit, the Pair Indicator will light up.
NOTE:
- Do not press the Pair button on the rear of the subwoofer, except for manual pairing.
- If the automatic pairing fails, pair the subwoofer with the main unit manually.

• Manual pairing

1. Ensure that all the cables are well connected and the main unit is in Standby mode.
2. Press and hold the Pair button on the rear of the subwoofer for a few seconds. The subwoofer will
enter the pairing mode and the Pair Indicator will blink quickly.
3. Press the button on the main unit or on the remote control to switch the main unit on.
4. After the wireless connection succeeded, the Pair Indicator will light up.
5. If the Pair indicator blinks, the wireless connection has failed. Unplug the cable of the subwoofer and
then reconnect the main cable after 3 minutes. Repeat step 1 ~ 4.
NOTE:
• If the wireless connection fails again, check if there is conflict or strong interference
(for example, interference from an electronic device) around your location. Remove these conflicts or
strong interferences and repeat the above procedures.
• The subwoofer should be within 6m of the soundbar in an open area.
• If a TV or an external device is connected, the main unit only AUX model and the subwoofer will
switch on automatically when the TV or the external device is switched on.
• If the main unit is not connected with the subwoofer and it is in On mode, the POWER Indicator will
flash. Follow step 1 ~ 4 above to pair the subwoofer to the main unit.

General Operation

Standby/ON

When you first connect the main unit to the mains socket, the main unit will be in Standby mode.
- Press the button on the unit or on the remote control to switch the unit ON.
- Press the button again on the remote control or on the unit to switch the unit back to STANDBY
mode. The POWER indicator will light up red.
- Disconnect the mains plug from the mains socket if you want to switch the unit OFF completely.
- The eco-friendly technology will switch this device to Standby mode automatically when the input
volume is too low or muted for 15 minutes. The device can be reactivated by pressing Standby
button and turning up the input device volume. Except for Optical & HDMI mode, the eco-friendly
control will switch the device to standby mode automatically when there is no input signal for 15
minutes.
12