Setting Alarm - Bresser WoW200 Bedienungsanleitung

3. Hold [MODE] for two seconds, the zone time offset will be dis-
played.
4. Enter the offset using [ + ] or [ – ].
5. Press [MODE] to exit.
HOW TO SET THE ALARM
There are total two alarms, namely alarm 1 and alarm 2 which can be
operated by press [AL. 1] an [AL. 2] respectively. The alarm setting pro-
cedure is listed as below.

SETTING ALARM 1

1. Press [AL. 1]
2. Press [ + ] or [ – ] to turn on / off the alarm function.
3. Press and Hold [AL. 1] button until the hour for alarm is flashing
4. Set the hour by press [ + ] or [ – ], and then press [AL. 1] button to
confirm.
5. Then, to set the minute by press [ + ] or [ – ], and then press [AL.1]
button to confirm.
6. If you would like to leave the alarm display and show calendar,
press [MODE] to show calendar. If you would like to switch to alarm
1 display, press [AL.1] button.
SETTING ALARM 2
1. Press [AL. 2]
2. Press [ + ] or [ – ] to turn on / off the alarm function.
3. Press and Hold [AL. 2] button until the hour for alarm is flashing
4. Set the hour by press [ + ] or [ – ], and then press [AL. 2] button to
confirm.
5. Then, to set the minute by press [ + ] or [ – ], and then press [AL.2]
button to confirm.
6. If you would like to leave the alarm display and show calendar, press
[MODE] to show calendar. If you would like to switch to alarm 1 dis-
play, press [AL.2] button.
29
GB/IE