Stroke Rate Regulator; Hints - Westfalia 84 93 44 Originalbetriebsanleitung

object. There is danger of serious injury or damages.
 When cutting metal pipes etc. make sure
the saw blade is longer than required for the
intended cut. A 4 cm longer saw blade will
avoid excessive kickback.

Stroke Rate Regulator


The stroke rate of the saw blade can be set differently by using
the stroke rate regulator (5). The desirable stroke rate depends
on the material and the saw blade being used.

Adjust the cutting speed on the relevant material. In general, a
higher speed is used for softer materials such as wood, compo-
sites and plastics. A lower speed is used for more precise cuts or
harder materials such as sheet metal, cable ducts and pipes.

Hints

TPI – teeth per inch/2.54 mm.
Saw Blade for Wood with 3 TPI
wood.
Saw Blade with 6 TPI
Universal Saw Blade with 10 TPI The flexible blade allows flush
 When sawing building materials observe the statutory require-
ments and the manufacturer's recommendations. Make sure the
saw blade and the blade speed are suitable for the workpiece.
 When sawing metal observe that the material can easily heat up.
The saw blade will harden and loose its cutting efficiency and
flexibility.
Using
Suitable for coarse sawing of
Suitable for fine sawing of wood
boards and for curves or plunge
cuttings.
sawing for coarse work in wood
and plastics.
19