Certificates And Approvals - Endress+Hauser iTEMP HART TMT162 Bedienungsanleitung

TMT162
Material
Terminals
CE mark
MTBF
Ex approval
Endress+Hauser
Housing
Die-cast aluminum housing AlSi10Mg/AlSi12 with powder
coating on polyester basis
Stainless steel 1.4435 (AISI 316L)
Stainless steel 1.4435 (AISI 316L) for hygienic applications
(T17 housing)
2
2.5 mm (12 AWG) plus wire end ferrules
10.0.7

Certificates and approvals

The measurement system fulfils the requirements demanded by the EU regulations.
Endress+Hauser acknowledges successful unit testing by adding the CE mark.
147 a according to Siemens Standard SN29500
For further details on the available Ex versions (ATEX, CSA, FM, etc.), please contact your nearest
Endress+Hauser sales organization. All relevant data for hazardous areas can be found in separate
Ex-documentation. If required, please request copies.
For USA and Canada follow these data:
• FM IS, NI Class I, Div. 1+2, Group A, B, C, D
Depending on location install per National Electrical Code (NEC) using wiring methods described
in article 500 through article 510. For Nonincendive installation an intrinsic safety barrier is not
required.
CSA IS, NI Class I, Div. 1+2, Group A, B, C, D
ATEX II1G EEx ia IIC T4/T5/T6
• FM XP, DIP, NI Class I, II, III, Div. 1+2, Group A, B, C, D, E, F, G
CSA XP, DIP, NI Class I,II,III, Div. 1+2, Group A, B, C, D, E, F, G
ATEX II2G EEx d IIC T6
• FM XP, DIP, IS, NI Class I,II,III, Div. 1+2, Group A, B, C, D, E, F, G
CSA XP, DIP, IS, NI Class I,II,III, Div. 1+2, Group A, B, C, D, E, F, G
ATEX EEx d, EEx ia
• FM+CSA XP, DIP, IS, NI Class I,II,III, Div. 1+2, Group A, B, C, D, E, F, G
ATEX II3G EEx nA IIC T4/T5/T6
• ATEX II1/2D
• CSA General Purpose
Nameplate
Aluminum AlMgl, anodized in black
1.4404 (AISI 316L)
-
Technical data
99