Installation; Quick Installation Guide - Endress+Hauser iTEMP HART TMT162 Bedienungsanleitung

TMT162
Endress+Hauser
Registered trademarks of Microsoft Corporation, Redmond, USA
® ®
• iTEMP and ReadWin 2000
Registered trademarks of Endress+Hauser Wetzer GmbH + Co. KG, Nesselwang, Germany
3

Installation

3.1

Quick installation guide

If the sensor is fixed then the unit can be fitted directly to the sensor. For remote mounting to a wall
or stand pipe, two mounting kits are available (→ Fig. 4). The illuminated display can be mounted
in four different positions (→ Fig. 2):
Fig. 2: Temperature field transmitter with sensor, 4 display positions, can be plugged-in in 90° steps
A: Sensor
1: Cover clamp
2: Housing cover with O-ring
3: Display with retainer and twist protection
4: Electronics compartment
1. Remove the cover clamp (1).
2. Unscrew the housing cover together with the O-ring (2).
3. Remove the display with retainer and twist protection (3) from the electronics compartment
(4). Adjust the display with retainer in 90°-stages to the desired position and rearrange it on
the particular slot in the electronics compartment.
4. Screw on the housing cover together with the O-ring. Mount the cover clamp.
Installation
61