National Geographic WETTER EXPERTE Bedienungsanleitung Seite 39

Setting up the time alarms
1. In clock and alarm mode, press ALARM/CHART to select alarm which you wish to confi gure.
2. Press and hold ALARM/CHART until hour starts fl ashing in the display.
3. Set alarm hour:
Press [▲] or [▼] to adjust value. Press and hold either button for fast advance.
Press ALARM/CHART to confi rm your selection.
4. Set alarm minutes:
Press [▲] or [▼] to adjust value. Press and hold either button for fast advance.
Press ALARM/CHART to confi rm your selection.
5. Set duration of snooze function (all three alarms share same snooze time duration):
Press [▲] or [▼] to adjust value. Press and hold either button for fast advance.
Press ALARM/CHART to confi rm your selection.
6. Upon completion the display will be returned to the alarm selection screen.
Note:
Pre-alarm cannot be activated if weekday alarm or single alarm is not enabled.
Disabling/entering snooze when time alarms are activated
To enter snooze:
Press SNOOZE to enable snooze function.
Note:
Alarm will automatically enter snooze mode if no key is pressed after the alarm sounds for 2 minutes.
This will occur for a maximum of three times.
To disable alarm(s): Press ALARM/CHART to disable the alarm(s).
Note:
For weekday alarm, pressing ALARM/CHART will only disable the alarm for the current day. The
alarm will be activated again the next day (if it falls within Monday to Friday).
Activating/deactivating radio clock reception
The base station synchronizes the time and date with radio clock broadcasts to maintain atomic clock
precision.
To turn this function on/off: Press and hold [▲].
If RC reception is activated, a triangular tower icon will start fl ashing beside the clock icon.
If RC reception is deactivated, the triangular tower icon will disappear.
Icon
(blinks)
RC Reception strength
Undefi ned data
Reception failed for 24 hours
Weak signal, but can be decoded
Strong signal
EN
39